Print Page | Close Window

Viper 5606v Remote Pairing

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=142043
Printed Date: May 15, 2024 at 3:34 AM


Topic: Viper 5606v Remote Pairing

Posted By: hooutoo
Subject: Viper 5606v Remote Pairing
Date Posted: November 17, 2016 at 9:36 AM

New to Forum so thanks for having me.

Having problem pairing my remote (7656v) to my Viper alarm system (5606v). The problem seems to lie in preparing the vehicle system for pairing.

The instructions from the manual for the 5606v system are as follows:

Prepare the vehicle system for pairing:
1. Open at least one of the vehicle’s doors.
2. Turn the key to the ON position.
3. Within five seconds press and release one time the Control but-
ton on the Control Center.
4. Within five seconds, press and hold the Control button. The sta-
tus LED will flash one time and the siren will chirp once to confirm
the system is ready for remote pairing.
5. Release the Control button and proceed to next step.

The problem is that I'm not getting any response from the control center, the LED never flashes.

I'm able to put the system into valet mode and then the LED lights up showing it's in Valet mode and of course I'm able to take it back out of Valet mode showing that at least I'm getting some sort of response from the Control Module. Is there some way of resetting the whole system. I've tried disconnecting the battery and letting it sit for a while but still get the same thing. Also I'm able to get the remote ready to pair following the steps in the guide. Any help would be greatly appreciated!






Print Page | Close Window