Accessory wire hookup 2006 durango

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=142232
Printed Date: July 14, 2025 at 11:58 AM

Topic: Accessory wire hookup 2006 durango

Posted By: trembuzz
Subject: Accessory wire hookup 2006 durango
Date Posted: December 13, 2016 at 10:04 AM

A previous owner had a python remote start installed but only the rear fan and not the front fan comes on. I'm guessing that the accessory wires got mixed up during the install. Should acc. 1, acc. 2 or both be hooked up to enable the front fan to engage

Replies:

Posted By: trembuzz
Date Posted: December 13, 2016 at 11:54 AM

Doing some follow-up research I found that the purple (-) wire has to have a relay hooked up. I'm guessing the original installer wasn't aware of this. Does someone know the proper way to hook a relay up for this wire?
Thanks in advance,
trembuzz

Posted By: i am an idiot
Date Posted: December 13, 2016 at 3:06 PM

Ground to terminals 30 and 85. Remote start unit's positive accessory output wire to terminal 86. 87 will be the negative output to provide - to the wire of the vehicle.

Posted By: trembuzz
Date Posted: December 14, 2016 at 8:50 AM

Thanks a bunch. Now I just have to get under the dash and figure out which model is installed. Should I be concerned about your username? lol
trembuzz posted_image

Posted By: i am an idiot
Date Posted: December 14, 2016 at 8:05 PM

Be concerned. Be very concerned.

Posted By: trembuzz
Date Posted: December 14, 2016 at 10:14 PM

Hmmm..... Your relay install info was spot on. But now this is very disconcerting. posted_image

Print Page | Close Window