Scytek Mobile 500rs not working
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=142308
Printed Date: April 20, 2024 at 4:08 AM
Topic: Scytek Mobile 500rs not working
Posted By: jstolk2
Subject: Scytek Mobile 500rs not working
Date Posted: December 26, 2016 at 4:05 PM
So several years ago I purchased this remote start. I've always used DEI remote starts, but thought I'd give this brand a shot. Back then I tried installing it in a 2003 GMC Sierra. I thought the pass lock was messing with me back then with this system, as it would remote start just fine, but only run for 5 seconds. I ended up giving up and put an Autostart on it and it worked fine. Now I've taken this Scytek off the shelf and am trying to install it in my 97 Dodge Dakota. There is no factory anti theft on this, so I know that isn't a problem. But the Scytek is doing the same thing. I have the minimal wires hooked up: 12V, Ign 1, Ign 2, Acc, Starter, ground. It starts fine, runs for 7 seconds, then shuts itself off. It does not try to restart. The lights on the control center simply flash once. If I hit the start button on the remote it just does the same thing all over again. Any thoughts?
Replies:
Posted By: jstolk2
Date Posted: December 26, 2016 at 4:33 PM
Never mind. Think I found the problem. Opened up the casing and I see a burnt component.
|