Print Page | Close Window

Diode isolate a PAC TR12

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=142479
Printed Date: July 06, 2025 at 11:14 PM


Topic: Diode isolate a PAC TR12

Posted By: tdbaker021
Subject: Diode isolate a PAC TR12
Date Posted: January 23, 2017 at 8:52 PM

Can you diode isolate the output wires on a PAC TR-12? I want to use the TR12 along with my DEI 530t. I want to connect 3 of the TR12 output wires to the DEI 530t orange wire. The GWA, channel 3, and the proximity pre-warn sensor from the alarm will connect to the PAC TR12 inputs. The 3 outputs will connect to the DEI 530t orange wire (with diodes) to roll the windows up when the system is armed, ch 3 is used or the pre-warn from the proximity sensor is activated.




Replies:

Posted By: tdbaker021
Date Posted: January 24, 2017 at 12:42 AM
tdbaker021 wrote:
Can you diode isolate the output wires on a PAC TR-12? I want to use the TR12 along with my DEI 530t. I want to connect 3 of the TR12 output wires to the DEI 530t orange wire. The GWA, channel 3, and the proximity pre-warn sensor from the alarm will connect to the PAC TR12 inputs. The 3 outputs will connect to the DEI 530t orange wire (with diodes) to roll the windows up when the system is armed, ch 3 is used or the pre-warn from the proximity sensor is activated.




Disregard this post. after reading more on the TR12 I can use the 3 inputs and one output connected to the 530t orange wire...


Print Page | Close Window