2006 Hummer H3 directed remote start relay
Printed From: the12volt.comForum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=142601
Printed Date: May 05, 2025 at 10:42 PM
Topic: 2006 Hummer H3 directed remote start relay
Posted By: kaczman
Subject: 2006 Hummer H3 directed remote start relay
Date Posted: February 13, 2017 at 10:27 AM
Hi all,
Im doing the remote start on my 06 H3 and I am stumped on this final wire.
Where in the world does the wire circled actually go to? it says Ignition of car or remote start unit.. but there's like 3. and if I run it to ignition of car, its just like bypassing the relay isnt it?
Any help would be appreciated.
Im doing the remote start on my 06 H3 and I am stumped on this final wire.
Where in the world does the wire circled actually go to? it says Ignition of car or remote start unit.. but there's like 3. and if I run it to ignition of car, its just like bypassing the relay isnt it?
Any help would be appreciated.
Replies:
Posted By: kreg357
Date Posted: February 13, 2017 at 11:00 AM
It goes to the H3's Ignition wire, which is WHITE/ Green. It could also go the the R/S's thick Ignition 1 output wire,
which connects to the H3's WHITE/ Green Ignition 1 wire. Photo below :
The relay won't be on all the time because it is also controlled by the R/S's (-) Status Output wire ( aka GWR ).
-------------
Soldering is fun!
which connects to the H3's WHITE/ Green Ignition 1 wire. Photo below :
The relay won't be on all the time because it is also controlled by the R/S's (-) Status Output wire ( aka GWR ).
-------------
Soldering is fun!
Posted By: kaczman
Date Posted: February 13, 2017 at 11:57 AM
Posted By: kaczman
Date Posted: February 15, 2017 at 11:56 AM
kreg357 wrote:
It goes to the H3's Ignition wire, which is WHITE/ Green. It could also go the the R/S's thick Ignition 1 output wire,
which connects to the H3's WHITE/ Green Ignition 1 wire. Photo below :
The relay won't be on all the time because it is also controlled by the R/S's (-) Status Output wire ( aka GWR ).
Thanks again for your help. One more thing.
When I click lock on the viper remote, it locks all the doors. But the unlock on the remote doesn't do anything lock wise, but I hear the alarm disarm.
What did I do wrong?