Mounting the Direct Electric 507M tilt sensor
Printed From: the12volt.comForum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=142892
Printed Date: May 12, 2025 at 8:21 PM
Topic: Mounting the Direct Electric 507M tilt sensor
Posted By: cj10
Subject: Mounting the Direct Electric 507M tilt sensor
Date Posted: April 21, 2017 at 10:09 PM
I have mounted the subject sensor inside the bottom of tge center console box on my Tacoma. Don't know why it won't trigger the alarm when I raise the rear tire about an inch off the ground. I know the sensor works when I tilt it. Do you think this sensor it's sensitive And I should mount it elsewhere? What are you folks experience? 
-------------
CJ
-------------
CJ
Replies:
Posted By: 12volt burnout
Date Posted: April 27, 2017 at 6:23 AM
Posted By: cj10
Date Posted: April 27, 2017 at 3:38 PM
That's not what the instructions says. Cutting the white wire increases the tilt sensor delay in becoming active. Cutting the black wire increases the tilt threshold from 1 to 3 degrees. Thanks. 
-------------
CJ
-------------
CJ