4Runner excalibur/omega factory alarm problem
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=143524
Printed Date: September 10, 2025 at 9:49 AM
Topic: 4Runner excalibur/omega factory alarm problem
Posted By: 1985sr5
Subject: 4Runner excalibur/omega factory alarm problem
Date Posted: September 05, 2017 at 2:03 AM
I have just installed a excalibur AL-1870-3DB with an omega blade-al in a 2013 toyota 4runner sr5 with the standard 80bit (G) key (Not the push to start). My question is does anyone know why if my alarm is armed and i remote start or lock the car again the factory alarm goes off? If i unlock first than remote start it works just fine.
Replies:
Posted By: howie ll
Date Posted: September 05, 2017 at 4:50 AM
Can you program an equivalent to the DEI safe start where it unlocks the doors prior to r/start, also have you connected key sense?
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: 1985sr5
Date Posted: September 06, 2017 at 9:19 PM
Yes all works good now i programged it to unlock first start the vehicle than do a lock. Thanks dont know why i didnt think of that.
|