2007 yukon with DB3 having issues with RXT

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=143658
Printed Date: May 13, 2025 at 11:47 AM

Topic: 2007 yukon with DB3 having issues with RXT

Posted By: cokelly
Subject: 2007 yukon with DB3 having issues with RXT
Date Posted: October 23, 2017 at 4:06 PM

Hello

I installed a DB3 with an XL202, 7765V remote and 6816T antenna. I have wired it just like the install guide says but after sitting for a few hours the viper remote won't work. The factory remotes work fine. I believe the vehicle is going into sleep mode. If I run the +12volt direct to another source will that solve my problem? Currently, all the wires go the OBd2 connector.

Thanks

Replies:

Posted By: cokelly
Date Posted: October 23, 2017 at 9:10 PM

One other solution I read was to run a negative output to the (-) door trigger. Would that mean to run the (-) RAP off out put to the (-) door trigger.

Can someone confirm this?

Posted By: xxrzdxx
Date Posted: December 26, 2017 at 7:46 PM

Did you ever find a solution to your problem, I'm afraid I'm having the same problem.

Print Page | Close Window