2013 Chrysler 200, Idatalink alca
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=143908
Printed Date: May 12, 2025 at 7:32 AM
Topic: 2013 Chrysler 200, Idatalink alca
Posted By: joshwright76
Subject: 2013 Chrysler 200, Idatalink alca
Date Posted: December 18, 2017 at 9:47 AM
First off thank you to all of you for your help you have been amazing.
According to idatalink all I need for this car is the al ca. No actual remote start is required. Does this sound right? From what I can tell it will start the car using the factory key fob. Idatalink doc#38461 page 9. Firmware RS-ch5... This is a new one to me so any advice is greatly appreciated...
-------------
Josh Wright
Replies:
Posted By: mgoetz74
Date Posted: December 18, 2017 at 10:22 AM
yes, with the alca you can do whats called RSR or remote start ready. You use your factory key fob and hit lock 3 times and it starts your car. draw backs are you only have the range your factory key fobs have. No extra fancy features like rear defrost,ect. You can add a compustar remote with antenna to it for around 75 to 100 bucks and get two key fobs with about 3000 feet of range or add on the drone mobile and get unlimited range from cell phone. You could also do a dircted dball3 and do the same but adding a remote to it is alot more expensive.
|