2016 f150 remote start problems
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=144046
Printed Date: May 09, 2024 at 4:25 PM
Topic: 2016 f150 remote start problems
Posted By: koz68
Subject: 2016 f150 remote start problems
Date Posted: January 18, 2018 at 1:53 PM
Hi I’m using a viper 5706v with a idatalink ads-alca. Does anybody know what wires from the viper get hooked up to the vehicle. Thanks
Replies:
Posted By: kreg357
Date Posted: January 18, 2018 at 2:40 PM
Follow the Type 1 diagram in the Install guide #39744 ( assuming your are going DBI D2D
and flashed the ADS AL-CA with DBI-AL(DL)-FM8 firmware ). Looks like just +12V and Chassis
Ground. The +12V can be confusing as the Viper has 4 +12V inputs. For your application
I would combine the thick Red and Red/Black from the main Ignition harness with the Red
wire at Pin 1 of the 6 pin harness and connect that to a suitable +12V source. Other
5706V wires would be Brown to the siren, White to the Parking Light control relay, thick
Pink IGN1 as per the diagram, Black/White to Chassis Ground ( if auto trans ), Gray to
Hood Pin ( if not Factory equipped ) and optionally Brown/Black to the (-) Horn wire.
-------------
Soldering is fun!
Posted By: koz68
Date Posted: January 18, 2018 at 5:04 PM
That did the trick thank you kreg357 I’ve been racking by brain for weeks trying to get it to work
|