2010 Honda Accord factory disarm wire

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=144112
Printed Date: May 06, 2024 at 6:36 AM

Topic: 2010 Honda Accord factory disarm wire

Posted By: godd dan it
Subject: 2010 Honda Accord factory disarm wire
Date Posted: February 01, 2018 at 9:22 PM

What color wire is the factory alarm disarm wire on a 2010 Honda Accord? Do I need to go into the driver’s side door?

Thanks

Replies:

Posted By: kreg357
Date Posted: February 02, 2018 at 5:02 AM

What bypass module are you using?

With a vehicle like that, I look for a full featured bypass module that takes care of the
transponder and does the locks and alarm. Saves a bunch of time and doesn't cost much
more. My favorite module for that car is the ADS AL-CA flashed with the DL HA3 firmware.
A few connections at the ignition switch allows the bypass module to supply Tach, Brake,
Hood, Door & Trunk Status and take care of the locks and alarm without going into the door.

-------------
Soldering is fun!

Posted By: godd dan it
Date Posted: February 02, 2018 at 3:02 PM

Yes I should have used a module that can do everything, but I was trying to save some money (a little more profit for me) on an install. I used the XK05 and completely forgot that it doesnt disarm the factory alarm. Now im paying for it in labor time.

Posted By: geepherder
Date Posted: February 02, 2018 at 6:01 PM

You should be able to do it at the power window master switch:

https://diagrams.marktoonen.nl/printlist.aspx?MakeID=3&ModelID=20116

https://www.revbase.com/BBBMotor/Wd/DownloadPdf?id=170220

-------------
My ex once told me I have a perfect face for radio.