Connecting Rearm & Disarm to Factory Alarm, 2000 Durango

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=144133
Printed Date: April 27, 2024 at 6:36 AM

Topic: Connecting Rearm & Disarm to Factory Alarm, 2000 Durango

Posted By: trey003
Subject: Connecting Rearm & Disarm to Factory Alarm, 2000 Durango
Date Posted: February 07, 2018 at 4:20 AM

I am installing a Viper 150 ESP remote start in a 2000 Durango.

I need to connect the 150 ESP disarm & rearm wires.

The Durango has 1 wire for lock & unlock. This appears to be the connection point for disarm & rearm.

Can I connect both of them to the same t-tap? Do I need to diode isolate the disarm or rearm wires?

Replies:

Posted By: monty_77
Date Posted: February 13, 2018 at 9:34 AM

First off it scares me when people say t-tap and remote start,

Your vehicle is a one wire lt green/Orange negative ground
-647 ohms for lockthis will also arm
-1562 ohms for unlock double pulse on door lock this will also disarm

If you need to disarm with out unlock then you will need to hook up the disarm wire with a -1562, But I do not think it factory alarm goes off when remote started, just when door is opened so most likely not need unless it does.

Also can set most remotestarts to unlock doors before start then lock after start this works too

Posted By: trey003
Date Posted: February 20, 2018 at 2:15 PM

Thank you for your help