Upgrade Clifford LCD Remote To OLED

Tried search but still unclear.

I want to know if I can upgrade my Clifford 330.3x LCD remote to the OLED remote if I also upgrade the antenna?

No, not according to the Directechs list.
Having said that, I think it's only the antenna, the lead is the same.
If you can obtain an antennna it's worthwhile plugging in the antenna then trying to pair the remote.


-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Depends on the Remote that you have! The 7941/7944 v/p/x and 7945v all work with the 6711t antenna. And is not compatible with the 6816t antenna (Which was replaced with the 6826t antenna).
Your 3303v should have the 6211T antenna which will not work with a OLED SST Remote. The SST Remotes need the 6711T Antenna.
The 6866T DS4(+) Antenna may work with the OLED SST Remotes but has not been tested to work so try at your own risk.

6711T antenna is compatible with any DEI remote that has
a flashing Blue light or LCD and ends with
FCC# EZSDEI 7941, 7944, 7945, 7752, 7652, 7754
Some older key fob transmitter remote
original cases may also have the following:
800-274-0200
FCC ID: EZSDEI7941
FCC ID: EZSDEI7944
FCC ID: EZSDEI7945
FCC ID: EZSDEI7752
FCC ID: EZSDEI7754
FCC ID: EZSDEI7652
FCC ID: EZSDEI7941 V/P/X
FCC ID: EZSDEI7944 V/P/X
FCC ID: EZSDEI7945 V
FCC ID: EZSDEI7752 V/P/X
FCC ID: EZSDEI7652 V/P/X

I have also tested that the 6816T and its replacement 6826T antenna's and corresponding 1-Way remote 7656v and it does work with my 5601, and 5902 Alarms Brains(CPU)
6826T Antenna's date codes: OK/17B
5601(non 18-pin) date code: OK/9D
5902 (18-pin) date code: OK/9L
The only issue I had was that I couldn't use the same 6826T antenna to program the same remote to both systems. Once the first antenna was used to program the remote to the 5601 it wouldn't program the remote to the 5902. When I used the 2nd 6826T I have on the 5902 with the same remote it programmed first try. Was only going for proof of concept, as I didn't enable the second car on the remote and try it that way with the same antenna on both. Car1 selection on the remote to 5601 and car 2 to 5902.

Thanks everyone.
Can confirm it worked with just swapping the antenna to the 6711t using the same cable.

Good to hear!

So theoretically I could change my 5906 alarm to utilize a 5706 LCD remote by changing the antenna as well?

5906, 5706, 5806 and 5606 all use the same antenna. So no antenna change would be needed just program remote to system. you can enable 2nd car function on the remote "disabled " by default and use the same remote on both systems. Once you have 2nd car function enabled you need to switch to 2nd car on the remote then run the pairing to the second system. Barring any firmware changes by DEI to disable the functionality of the other remotes.

Calling lurch228, or anyone who might know.

I also have an old Viper 5900 with the original lcd 2 way 7701 remote. I believe it is SST as well. I bought a nos color oled remote from a 7900 I think it is a 7541 remote. It will not pair to the 5900 but I am curious if there is any antenna upgrade for the 5900 to allow it to accept the 7900 oled remote (or even any of the newer 2 way remotes.)

Thanks everyone!

5900 is SST-Keeloq antenna (6701T) coding and 7900 is ASK-Keelog antenna (6511t)coding. Too the best of my knowledge the the remote and antenna must match then it's trial and error to see what works. Just make sure that you delete all remotes from brain and antenna first then pull power from brain and then swap antenna. I had to program a 1-way remote before the 2-way remote would pair to the brain after a antenna swap from a 1-way antenna system to a 2-way antenna upgrade. At least that is what worked for me, at the time I didn't think to try zapping the brain with the bit-writer so can't say if that would also work . If you try it and it does please post your results to keep the learning moving forward.

As I'm learning the hard way, don't bother trying to get an XDR remote to work with an older non DS4/DS4+ brain
I believe it's forward compatible, but not back

Now the rest of us also know as you chose to be the guinea pig on this one.

I have both the 5904/5906 brains and I wanted to upgrade to the 2 way LED remote 7856V according to this post it should work but after I change the antenna to the 6826T then my 7944v/79445 will no longer work can anyone confirm?