Print Page | Close Window

2011 Toyota Corolla Alarm Install

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=144297
Printed Date: May 03, 2024 at 2:06 PM


Topic: 2011 Toyota Corolla Alarm Install

Posted By: mavue
Subject: 2011 Toyota Corolla Alarm Install
Date Posted: April 08, 2018 at 9:13 PM

I need help finding the door trigger wire. I have found the front driver and rear driver side wires but they are in different locations. I am trying to use the dome light supervision wire as a trigger but cannot locate that either. Any help is appreciated.posted_image



Replies:

Posted By: howie ll
Date Posted: April 09, 2018 at 5:37 AM
Look where it says dome supervision.
You can safely use that as your door trigger.
You don't need dome supervision because it's built into the vehicle.
Usually a 3 pin plug at the dash fusebox or at the actual domelight.
The wire that goes to ground if your in the car; lock it the light should go out, unlock and open a door that wire will go to ground.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.




Posted By: mavue
Date Posted: April 10, 2018 at 1:55 AM
Thank you.





Print Page | Close Window