2012 Ford Taurus w/CM7200 and Blade AL
Printed From: the12volt.comForum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=144658
Printed Date: May 13, 2025 at 3:06 PM
Topic: 2012 Ford Taurus w/CM7200 and Blade AL
Posted By: brianl62
Subject: 2012 Ford Taurus w/CM7200 and Blade AL
Date Posted: August 12, 2018 at 11:30 AM
New install on a 2012 Ford Taurus with a Push To Start ignition. I have flashed the Blade AL with DL FM5 v1.6 and I'm at the part where I attach to the car, I have the original Ford FOB (without battery) in the backup transceiver but when I put the car into the on position (long push) the blue led on the blade does not go blue. I was following the "Module Programming Procedure - One KeyFOB & KLON" procedure from idatalink.
I'm using the low current ignition CN3 connector/harness. I do not have the parking lights hooked up to the car, I'm using a multimeter to monitor the output to ground. Connector C5 is not connected. The 7200 is also grounded through the CN3 low current connector/harness.
Wiring is per this:
Module programming instructions:
Any ideas??
-------------
Brian
I'm using the low current ignition CN3 connector/harness. I do not have the parking lights hooked up to the car, I'm using a multimeter to monitor the output to ground. Connector C5 is not connected. The 7200 is also grounded through the CN3 low current connector/harness.
Wiring is per this:
Module programming instructions:
Any ideas??
-------------
Brian