Print Page | Close Window

Ford Powercode PATS Bypass

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=144723
Printed Date: May 09, 2025 at 8:22 AM


Topic: Ford Powercode PATS Bypass

Posted By: mikeluscher159
Subject: Ford Powercode PATS Bypass
Date Posted: September 12, 2018 at 12:20 PM

Hi all,

I won me an old Code Alarm made Ford Powercode Gold dealer installed remote start for my '06 Taurus

But it seems the bypass kit it specifics is obsolete

Is there anything else that'll work or interchange for 1L2Z-19G365-AB

Thanks for the help
-Mike



Replies:

Posted By: Ween
Date Posted: September 12, 2018 at 7:34 PM
Should be able to use any transponder bypass that is compatible with Fords. There should be a blue/black in the 'B' harness that is
labeled active output...ground while running. It will have a ground signal when the remote start is operated. Hope this helps.



Posted By: mikeluscher159
Date Posted: September 16, 2018 at 1:27 PM
I got a Fortin EVO-Key, because it's inexpensive and supports my vehicle, now my problem is how do I get it to interface with the Start module

The install instructions for the manual show me plugging into a 4 pin header connector on the module with the Ford bypass

None of the connectors on this Fortin seem to fit?

I can install the Fortin, and I can install the Remote start, I just don't know how they'll talk to each other

posted_image

posted_image



Posted By: eguru
Date Posted: September 16, 2018 at 7:52 PM
You need to make the connections per 1A in the installation guide.

Getting a 8L3Z-19G365-BA on eBay would probably have been simpler though.



Posted By: mikeluscher159
Date Posted: October 18, 2018 at 5:02 PM
I see

I didn't know I had to do that cutting, but I did eventually figure it all out

I tried a 8L3Z, it doesn't clear the black key holder bezel thingy clipped to the barrel

It's designed for flat metal key surrounds

Thanks for all the help



Posted By: chev104275
Date Posted: October 18, 2018 at 7:34 PM
In order to use the 8L3Z you need to pop out the ingition cylinder put on the ring then reinstall the cylinder.

-------------
If i Can't Install it    I Don't need it   Joe


Print Page | Close Window