BMW E30 - Viper 4203v Remote Start Install
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=144827
Printed Date: April 28, 2024 at 11:26 PM
Topic: BMW E30 - Viper 4203v Remote Start Install
Posted By: paul-z
Subject: BMW E30 - Viper 4203v Remote Start Install
Date Posted: October 03, 2018 at 11:16 AM
Hey guys,
Looking for some assistance here. I have this unit wired up and am getting the following symptoms:
- Upon long button press, I'm getting multiple beeps and a green light on my remote
- I hear a click in the main unit and see a temporary spike in voltage on my accessory wire
- I get no ignition/crank, followed by 4 double-beeps on the remote
Using a voltmeter, I've narrowed my car-side wiring to the following:
Red - 12v constant
Violet - see's 12v when key in accessory position
Green - see's 12v when key in ignition position
Green/Grey - also see's 12v when key in ignition position - apparently this is the rear defogger
Black - Starter
Viper wiring states the following:
Red - 12v constant
Pink - Output to ignition
Purple - Output to starter
Orange - Output to accessory
Red - 12v constant
Pink/White - Programmable output for accessory or ignition
My wiring:
- Red from car tied into BOTH Red's on Viper
- Violet from car tied into Orange on Viper
- Green from car tied into Pink on Viper
- Black from car tied into Purple on Viper
- Green/Violet from car not used
- Pink/White from viper not used
Any help would be greatly appreciated!
Replies:
Posted By: cpalmer
Date Posted: October 03, 2018 at 9:37 PM
Have you programmed tach signal?
Posted By: paul-z
Date Posted: October 04, 2018 at 12:30 PM
I believe I did the tach learning correctly, but will attempt it again tonight and see if that works.
I know my car has an ignition advance relay under the hood. When I use the key, I hear this relay click. When using the remote start it doesn't.
I'm wondering if this has something to do with my problem?
|