2006 Nissan Pathfinder, Viper 5305v

Hello !! Does anybody knows how to program the pink/white ignition 2 to be an accesory 2 on a viper 5305v. Is for a 2006 nissan pathfinder.

-------------
Tavo112085

Menu 3, item 6, option 2 (2 chirps)

the manual is in the downloads section if you don't have it:

1. Open a door.
2. Turn the ignition on, then off.
3. Select a Menu. Press and hold the Control Center button. The number of siren chirps indicates the menu
number. 1 LED flash and chirp indicates Menu 1, 2 LED flashes and chirps - Menu 2 and 3 LED flashes
and chirps for Menu 3.
4. When the desired menu chirps are heard, release the Control button.
5. Select a Feature. Press and release the Control Center button the number of times corresponding to the
feature you desire to change. Then, press and hold one more time to select the features.
6. Program the Feature. While still holding the Control Center button, you can program the feature using
the remote control or by pulsing a (-) on the 24 pin White/Blue Activation Input wire.



-------------
My ex once told me I have a perfect face for radio.

Thank you for the info!! My firend told me to wire it with a relay. Im not sure if that is possible!!

-------------
Tavo112085

Install Manual 5305
You may want to have this for reference.

-------------
Steve G

tavo112085 wrote:

---

My friend told me to wire it with a relay. I'm not sure if that is possible!!

---

Just make sure you are using the heavy gauge pink/white wire from the 10 pin harness and you will not need a relay.

If you were using the pink/white small wire from the 24 pin connector you would definitely need to use a relay.

-------------
Steve G

FYI   (The 2nd starter will require a relay)

NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehicle will NOT Remote Start when the Engine is cold.



-------------
Steve G

Hello everybody!! I installed my viper 5305 remote starter
When i push the start button it only clicks inside the romote start but nothing happen. Any one have any idea of what could be the problem

-------------
Tavo112085

When you try to start, do you get error chirps? Is the toggle switch plugged in/on? If you do shutdown diagnostics, how many LED flashes do you get?

-------------
My ex once told me I have a perfect face for radio.

No chirps, no toggle swicht. I did no do a shut down diagnostic yet.


-------------
Tavo112085

Also try touching the white/blue remote start activation wire to ground. See if that starts it.

Do the other functions work with the remote (arm/disarm)? If not, you could try relearning the remote. If that doesn't work, verify all your power/ground connections as well as checking the antenna cable for continuity.

-------------
My ex once told me I have a perfect face for radio.

Arm and disarm works. I grounded the white/ blue wire but all i hear is 3 clicks inside the remote start but nothing happen. I going to check my connections.

-------------
Tavo112085

I connected black/white (-) parking brake input from the
24 pin to ground. Now my remote start works!! Thank you
guys for the help!!

-------------
Tavo112085