Print Page | Close Window

Viper 5806 Alarm Goes Off When Setting Manual Transmission Mode

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=144935
Printed Date: May 17, 2024 at 2:10 AM


Topic: Viper 5806 Alarm Goes Off When Setting Manual Transmission Mode

Posted By: matthew279
Subject: Viper 5806 Alarm Goes Off When Setting Manual Transmission Mode
Date Posted: November 09, 2018 at 6:13 PM

Just finished installing a Viper 5806V in a Tacoma that previously had Viper 5901. When I try to set the manual transmission mode, everything works fine until I close the truck and select lock on the keypad. My truck turns off, but my alarm goes off a few seconds later. I currently have the green/white Factory Alarm Arm Output connected to the negative door trigger input. I connected it there with my old system to turn the headlights off when the remote start turned off. With the 5806, I think the truck is locking/arming, and then 4 seconds after my remote start deactivates, my alarm goes off because it thinks the door is opening. I disconnected the wire and enabled manual transmission mode fine, but then my headlights remained on. I could manually turn off the headlights each time, but I'm sure I'll forget often. Is there a better wire to use for this situation?



Replies:

Posted By: matthew279
Date Posted: November 09, 2018 at 6:14 PM
2003 Tacoma V6



Posted By: lurch228
Date Posted: November 09, 2018 at 10:10 PM
Give this a try to isolate the rearm from the trigger input.posted_image


Print Page | Close Window