2010 Subaru Forester, Evo-All, Python 4105 Only Starts w/Key in Ignition
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=145026
Printed Date: May 21, 2024 at 7:40 PM
Topic: 2010 Subaru Forester, Evo-All, Python 4105 Only Starts w/Key in Ignition
Posted By: ahartung
Subject: 2010 Subaru Forester, Evo-All, Python 4105 Only Starts w/Key in Ignition
Date Posted: December 09, 2018 at 4:28 PM
2010 Subaru Forester automatic. Evo-All and Python 4105 remote start.
The car will not remote start without the key in the ignition. It will go through the process, but the starter never engages. I've checked that the IMO Data wires are properly connected before and after the cut. Checked voltage on all CAN connections.
Evo programmed correctly as far as I can tell. Units connected via datalink cable, D2D protocol programed for Evo. Remote start key fob operates locks correctly, but OEM fob not working.
Obviously something is wrong with the bypass, but I don't know what to check next.
Replies:
Posted By: kreg357
Date Posted: December 09, 2018 at 6:13 PM
By EVO-ALL in D2D protocol, you checked the F3 Option box during the flash process?
Did you make the IGN1 hardwire connection from the 4105 to the EVO-ALL Pin A-1?
-------------
Soldering is fun!
Posted By: ahartung
Date Posted: December 09, 2018 at 7:05 PM
kreg357 wrote:
By EVO-ALL in D2D protocol, you checked the F3 Option box during the flash process?
Correct.
kreg357 wrote:
Did you make the IGN1 hardwire connection from the 4105 to the EVO-ALL Pin A-1?
Yes.
Posted By: kreg357
Date Posted: December 10, 2018 at 6:17 AM
Good so far.
Double check that the EVO-ALL Light Blue/Black wire at A-10 is connected to correct ( away ) side of the cut IMO DATA wires at the BCM connector.
The DCryptor part of the module programming went OK, too?
-------------
Soldering is fun!
Posted By: ahartung
Date Posted: December 10, 2018 at 8:28 PM
I went through and checked every connection again, don't know what I did, but it now works.
One odd thing though, after remote starting, the diver's side headlight is on, but the passenger's isn't. It is only as bright as daytime running lights, not full. I was testing it at night. Lights were normal when key started, off.
Posted By: kreg357
Date Posted: December 11, 2018 at 6:30 AM
Maybe a connector was loose somewhere. I always solder all my connections, never an issue.
With the Parking Lights, make sure the 4105 is set to (-) Parking Light output via the jumper and/or try going to the Black/White wire at the Headlight switch in the steering column.
-------------
Soldering is fun!
|