08 TrailBlazer, Compustar RS1B-AL Remote Start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=145117
Printed Date: June 09, 2024 at 9:28 AM
Topic: 08 TrailBlazer, Compustar RS1B-AL Remote Start
Posted By: buzzstpoint
Subject: 08 TrailBlazer, Compustar RS1B-AL Remote Start
Date Posted: December 29, 2018 at 1:19 PM
2008 trailblazer LT
Compustar RS1B-AL
Does anyone have a wiring diagram for this unit for the trailblazer?
I have the main wires hooked up, but nothing seems to be working. R/S clicks and thats it. The bypass blade only flashes red led.
Any help you can give would be great.
Replies:
Posted By: iskidoo
Date Posted: December 30, 2018 at 12:24 AM
BLADE-AL GM1
CM7200------------- Steve G
Posted By: buzzstpoint
Date Posted: December 30, 2018 at 8:00 PM
Remote start is installed and working correctly..
**Notice**
Compustar RS1B-AL from Best Buy (perhaps other places) comes with the "Blade-AL" for integrations and bypass. It is NOT programmed!!
You will either need to buy the data cable (ADS-USB) for the firmware, or know somebody that has one. In my case we know a guy from best buy that flashed it for us.
This R/S lit right up after the program.
As far as the "Nothing is working" complaint from me. I tend of overthink and over complicate things, I'm used to older Remote starts that would take you better part of a day to install and have to spice in 30 wires and 3 relays to get these working. This unit is literally your ignition wires, brake, parking lights, horn and OBDII data wire.
A little tip I found on the Parking light wire, Tech bulletin says use the Grey/black wire on back of headlight switch. This is a Neg wire, that would require you to run a relay. Instead if you go back to your ignition wires by the column, By the main connector you'll see a large bundle of wires running one side of the dash to the other. Inside this bundle of wire there is a 12v + "Brown" wire, that is your parking lights. Tap in there from your Remote start and no relay needed. That was actually the hardest part of the install.
Thanks fellas.
|