2006 Buick Rendezvous Remote Starter Ignition Wire Clarification
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=145303
Printed Date: April 29, 2024 at 7:40 AM
Topic: 2006 Buick Rendezvous Remote Starter Ignition Wire Clarification
Posted By: dustint91
Subject: 2006 Buick Rendezvous Remote Starter Ignition Wire Clarification
Date Posted: March 18, 2019 at 10:56 AM
I am installing a Compustar CS800s with a Fortin INT-SL+ in my '06 Rendezvous.
All of the info I can find online just says that the pink ignition wire from the Fortin unit should go to the pink ignition wire in the ignition harness of the car. The issue is, I do not know which pink wire to use. I see 3 pink wires in the ignition harness. Does anyone know what pin the wire is on the ignition harness connector? Or an other way to identify it? Is there a way for me to test the voltage at different key positions to determine which one is the right one? Thank you for any help.
Replies:
Posted By: geepherder
Date Posted: March 18, 2019 at 11:58 AM
The correct wire will show 12 volts with the key in both the Run and Start positions.
-------------
My ex once told me I have a perfect face for radio.
Posted By: dustint91
Date Posted: March 18, 2019 at 12:22 PM
Will only one of the pink one's do that? I can't recall if I tested for that on all of them, but I feel like I had at least 2 that showed that. I will check them again when I get home tonight.
Posted By: dustint91
Date Posted: March 18, 2019 at 12:24 PM
Also, the Compustar has a blue wire that you can decide it's function with a jumper. Default function is Ignition 2. I have not connected this anywhere. Do I need this on my car? If so, where does it connect and do I need to move the jumper?
Posted By: geepherder
Date Posted: March 18, 2019 at 1:59 PM
I can't tell for sure if only one will test ignition. They might be connected in parallel. Your Fortin install manual should say what connections are required.
I'm not familiar with Compustar, perhaps someone else can answer that.
-------------
My ex once told me I have a perfect face for radio.
Posted By: iskidoo
Date Posted: March 18, 2019 at 5:24 PM
 ------------- Steve G
Posted By: iskidoo
Date Posted: March 18, 2019 at 5:27 PM
dustint91 wrote:
Do I need this on my car? If so, where does it connect and do I need to move the jumper?
Yes leave jumper set to ignition 2 and connect it to the green wire shown in photo in my previous post. ------------- Steve G
Posted By: dustint91
Date Posted: March 19, 2019 at 12:55 PM
Wow nice pictures! I could have used that a few days ago haha. I ended up getting it sorted out last night before seeing this. Took lots of digging online and reading a billion posts. Though seeing these pictures does give me some reassurance that I got the right wires since I did it just as your pictures show. Thank you!
Posted By: iskidoo
Date Posted: March 21, 2019 at 10:23 PM
Posted By: iskidoo
Date Posted: March 21, 2019 at 10:47 PM
|