5x10 Not Responding, Red LED Flashes Once
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=145597
Printed Date: May 21, 2024 at 11:37 AM
Topic: 5x10 Not Responding, Red LED Flashes Once
Posted By: paul.roberts.82
Subject: 5x10 Not Responding, Red LED Flashes Once
Date Posted: August 26, 2019 at 5:10 PM
5x10 that has been installed a few years. noticed it was no longer responding to the fob or the valet button. pulled it apart and the LED on the top is just flashing red once at a time. I assumed it was just done so i bought a new one and it does the same thing. I can no longer get into my xkloader or expresskit.com.
2014 jeep wrangler
any help is appreciated, do i need to be a dealer to use the xkloader? its been a few years since i played with this stuff.
Replies:
Posted By: iskidoo
Date Posted: August 26, 2019 at 11:00 PM
Did you try swapping antennas or reuse the original?
-------------
Steve G
Posted By: paul.roberts.82
Date Posted: August 27, 2019 at 6:50 PM
reused the original,im not sure if the new one had one now that i think about it. im sure it does. the current one in the jeep is the long range antenna with the built in valet button.
thanks for the help
Posted By: paul.roberts.82
Date Posted: August 27, 2019 at 7:13 PM
also i will add, my gps unit has no lights with the old alarm or the new alarm. valet button does not work with either one. im baffled, there is really no electronics to go bad other than the actual alarm so i thought with the new one i could atleast see the valet button working.
Posted By: iskidoo
Date Posted: August 27, 2019 at 7:51 PM
Have you checked the fuses to the alarm unit?
-------------
Steve G
Posted By: mgoetz74
Date Posted: August 28, 2019 at 11:32 AM
did you flash the new one for the vehicle? this is the manual, has the trouble codes at the end hope it helps
https://directechs.blob.core.windows.net/documents/dds-chrysler_fsg_en_nf20190411.pdf
-------------
33 years as a installer now just a retired old guy. Favorite thing to install/topic are remote starts/car alarms. Stop using test lights!!!
Posted By: paul.roberts.82
Date Posted: August 30, 2019 at 7:04 PM
today i put the new 5x10 back in without connecting the GPS unit and it flashes red/green/orange over and over. still nothing on the valet.
it has not been programmed. guess i need to find someone local to help me out.
can anyone remote in and program it from my PC if i have a loader already?
Posted By: paul.roberts.82
Date Posted: August 30, 2019 at 7:05 PM
iskidoo wrote:
Have you checked the fuses to the alarm unit?
yes
Posted By: paul.roberts.82
Date Posted: August 30, 2019 at 7:06 PM
mgoetz74 wrote:
did you flash the new one for the vehicle? this is the manual, has the trouble codes at the end hope it helps
https://directechs.blob.core.windows.net/documents/dds-chrysler_fsg_en_nf20190411.pdf
new one has not, i have a loader but lost my access to the web site.
|