Python Window Roll Up Aux - Relay or Module?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=145699
Printed Date: May 02, 2025 at 7:20 PM

Topic: Python Window Roll Up Aux - Relay or Module?

Posted By: mckee1710
Subject: Python Window Roll Up Aux - Relay or Module?
Date Posted: October 21, 2019 at 7:15 PM

Researching to install Python 413 remote start/keyless entry on my 97 Chevy K1500. Would like to utilize the aux/trunk latch to roll my windows up, as I often leave them cracked. The aux is the typical low amp negative output that lasts for the duration of the transmission, per the install sheet. Can I just wire this to two SPST relays on each of the window up wires between the switch and the window motors? Or do I need to use a dedicated window module like the DEI 529T?

Replies:

Posted By: iskidoo
Date Posted: October 22, 2019 at 8:10 AM

Most recommend the module for the limiter circuit that is built in.

https://www.the12volt.com/installbay/forum_posts.asp?tid=22460

-------------
Steve G

Posted By: mckee1710
Date Posted: October 22, 2019 at 11:18 AM

Makes sense, thanks!

Print Page | Close Window