Compustar CS925s Programming
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=145895
Printed Date: May 23, 2024 at 12:43 PM
Topic: Compustar CS925s Programming
Posted By: craig dumford
Subject: Compustar CS925s Programming
Date Posted: December 31, 2019 at 12:14 PM
I recently purchased a compustar cs925s with the cm900 brain. I installed it in my 2003 f350 diesel and it is functioning. I am trying to change the programming options so that it is diesel mode and waits for the glow plugs to warm up before starting. I am following the instructions in the manual, as far as I can tell, but am not getting the options set correctly. I tried calling compustar for help but they will not give support to self install. I did not hook up the horn wire, but he parking lights are hooked up an I am getting flashes from the lights. Has anyone programmed one of these that could offer me some help on what I am doing wrong?
-------------
Craig
Replies:
Posted By: kreg357
Date Posted: January 01, 2020 at 5:21 PM
Which Option are you trying to change, 2-03?
You should be able to change this option with the remotes but you can only use option II for 12 seconds or option III for 7 seconds. You would need the OP-500 to go into Special Option Group 1 to select another seconds value. The full CM900 install guide is in the Downloads section and should give the needed instructions for programming with the remotes. If I remember correctly, timing is important and getting the two buttons pressed at the same time is critical. It takes some practice. I took the easy route and got the OP-500 programmer.
Do you by any chance have the ADS USB programming cable and access to the iDatalink WEB Flash site? If so, there might be another way.
-------------
Soldering is fun!
|