Viper 5902v Stuck in Valet Mode, Need Pairing
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=145926
Printed Date: May 13, 2024 at 1:11 PM
Topic: Viper 5902v Stuck in Valet Mode, Need Pairing
Posted By: madrigal87
Subject: Viper 5902v Stuck in Valet Mode, Need Pairing
Date Posted: January 06, 2020 at 11:04 PM
Hi i have a viper 5902v and im trying to pair it. So i open the door turn the switch on the press and release and press it again and the lights turn on but it doesnt blinks i cant pair it it goes on valet mode
Help please 🤗
-------------
francisco madrigal
Replies:
Posted By: madrigal87
Date Posted: January 07, 2020 at 9:40 PM
Having problem pairing my remote (7656v) to my Viper alarm system (5902v). The problem seems to lie in preparing the vehicle system for pairing.
The instructions from the manual for the 5902v system are as follows:
Prepare the vehicle system for pairing:
1. Open at least one of the vehicle’s doors.
2. Turn the key to the ON position.
3. Within five seconds press and release one time the Control but-
ton on the Control Center.
4. Within five seconds, press and hold the Control button. The sta-
tus LED will flash one time and the siren will chirp once to confirm
the system is ready for remote pairing.
5. Release the Control button and proceed to next step.
The problem is that I'm not getting any response from the control center, the LED never flashes.
I'm able to put the system into valet mode and then the LED lights up showing it's in Valet mode and of course I'm able to take it back out of Valet mode showing that at least I'm getting some sort of response from the Control Module. Is there some way of resetting the whole system. I've tried disconnecting the battery and letting it sit for a while but still get the same thing. Also I'm able to get the remote ready to pair following the steps in the guide. Any help would be greatly appreciated!
-------------
francisco madrigal
Posted By: silvercivicsir
Date Posted: January 09, 2020 at 4:34 PM
did you originally install the 5902? I have seen some cases where the door trigger was never hooked up. Might want to try ground out the door pin wire on the brain to see if that fixes the problem.
Posted By: madrigal87
Date Posted: January 12, 2020 at 12:11 PM
No i did not a guy dis for me is that the door trigger
Main brain
Violet (+) DOOR TRIGGER INPUT That one Or this one
Green (-) DOOR TRIGGER INPUT (N/C* OR N/O)
Do i have to look when i open the door ?
Or i just have to ground it out to just ground and which cable?
Thanks 😊
-------------
francisco madrigal
|