2011 Subaru Outback, Compustar CM900-AS, ADS Blade-AL
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=145929
Printed Date: May 17, 2024 at 2:10 PM
Topic: 2011 Subaru Outback, Compustar CM900-AS, ADS Blade-AL
Posted By: ukie219
Subject: 2011 Subaru Outback, Compustar CM900-AS, ADS Blade-AL
Date Posted: January 08, 2020 at 11:02 AM
The doors do not lock or unlock with the new fob. I have not landed individual wires for the door locks (from CN3) because I assumed that the Blade would be communicating through the Can bus. Just looking to know for sure that I still have to land those additional wires. Thank you.
Replies:
Posted By: mgoetz74
Date Posted: January 08, 2020 at 11:26 AM
https://images.idatalink.com/corporate/Content/Manuals/DL-SUB3/COM-BLADE-AL(DL)-SUB3-EN_20190726.pdf
you have to use a relay and wire the door lock special on Subaru.
-------------
33 years as a installer now just a retired old guy. Favorite thing to install/topic are remote starts/car alarms. Stop using test lights!!!
Posted By: ukie219
Date Posted: January 08, 2020 at 6:12 PM
Thank you for your reply, unfortunately I followed that diagram and this is why I'm here. I'm not 100% clear whether the blade is using the can bus for the door locks or do I have to land the actual wires from Cn3.
Posted By: kreg357
Date Posted: January 09, 2020 at 7:41 AM
There is no need to connect the R/S CN3 wires to the Outbacks Lock / Unlock wires. The Blade-AL will handle the locks and Factory Alarm for you via it's connections to the car. You will need the relay shown in the Type 3 Install diagram in place and wired correctly to the Keyless wire.
-------------
Soldering is fun!
Posted By: ukie219
Date Posted: January 09, 2020 at 11:44 AM
Thank you for spelling it out for me. Apparently I used a bad relay initially. After changing it everything works correctly. Again, thank you kindly.
|