2000 Chevrolet Blazer, Viper 5305v
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=145941
Printed Date: May 10, 2025 at 2:02 AM
Topic: 2000 Chevrolet Blazer, Viper 5305v
Posted By: provolone
Subject: 2000 Chevrolet Blazer, Viper 5305v
Date Posted: January 13, 2020 at 11:29 AM
Hi everyone I need some help viper 5305v I have a 2000 Chevy blazer I have one wire for factory disarm the viper has two Wires factory arm and factory disarm so do both these wires get used or just one and would I need a relay as well thanks. Also another problem is what do I hook up so my alarm will go off if I open the doors the dome light or the door pins thanks
-------------
Provolone
Replies:
Posted By: mgoetz74
Date Posted: January 13, 2020 at 12:02 PM
i wouldn't worry about the are wire since chevy arms on lock just to the disarm wire, no relay needed-
Factory Alarm Disarm lt. green (driver door key cylinder)- BCM in center console below radio, purple plug, pin B3
as for the door triggers use the green door trigger on the viper
Left Front Door Trigger tan BCM in center console below radio, purple plug, pin B4
Right Front Door Trigger orange BCM in center console below radio, purple plug, pin B2
Left Rear Door Trigger dk. blue/white - BCM in center console below radio, lt. blue plug, pin B11
Right Rear Door Trigger same as left rear door trigger
-------------
33 years as a installer now just a retired old guy. Favorite thing to install/topic are remote starts/car alarms. Stop using test lights!!!
Posted By: provolone
Date Posted: January 13, 2020 at 12:36 PM
Ok do I need to Diode Isolate the door triggers I have in4007 rectifier Diode if yes will that work
-------------
Provolone
Posted By: provolone
Date Posted: January 27, 2020 at 11:22 AM
Hi I have a 2000 Chevy blazer I have a viper 5305v remote start and security I have everything hooked up and working fine except for horn honk I hooked it up to the schematic for the horn and still have nothing wanted to know if it’s something to pre-program from factory to stay off and I would have to turn it on or is there a way I can test that the brown /black wire has 200ma
-------------
Provolone
Posted By: geepherder
Date Posted: January 27, 2020 at 1:50 PM
You can see if the output is enough to trigger a relay. Connect terminal 85 to the horn output wire of the alarm. Connect 86 to positive 12 volts. Set and trigger the alarm (open a door, etc.). Feel/listen to the relay to see if it's clicking. If it is, the output of the alarm is working.
-------------
My ex once told me I have a perfect face for radio.
|