2010 Nissan Rogue, Viper 4806V and EVO All Bypass

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=145951
Printed Date: May 09, 2025 at 11:39 PM

Topic: 2010 Nissan Rogue, Viper 4806V and EVO All Bypass

Posted By: buddyle2002
Subject: 2010 Nissan Rogue, Viper 4806V and EVO All Bypass
Date Posted: January 18, 2020 at 6:26 PM

Can someone give me some input on this install. I already got the suv installed and remote start working without any issue, however I can't seem to get the lock and unlock to work with this setup. Even connected the lock and unlock from the remote start module to car OR remote start module to evo all, both way don't work, only getting the beeps from the horn. Highly appreciated if i could get any input.

Green from the remote module connected to POWER LOCK PINK (-) TYPE B in DRIVERS KICK PANEL or BCM, (WHITE, 15-PIN PLUG) PIN 5, NOTE #2

Blue from the remote module connected POWER UNLOCK BROWN(-) TYPE B in DRIVERS KICK PANEL or BCM, (WHITE, 15-PIN PLUG) PIN 6, NOTE #2

Here is my setup as pics below.
posted_image

Replies:

Posted By: cpalmer
Date Posted: January 18, 2020 at 10:12 PM

Did you connect to the wire at the BCM or the kick panel?
Can you ground the wire directly to metal and cycle the door locks?

Posted By: buddyle2002
Date Posted: January 20, 2020 at 12:43 AM

I connected to lock/unlock wires at the kick panel. I don’t understand your other question.

Posted By: djdeito
Date Posted: February 06, 2020 at 4:15 PM

does your vehicle has the standard key, intelli-key or standard key with oem alarm?

Posted By: silvercivicsir
Date Posted: February 07, 2020 at 12:36 PM

use the factory arm / disarm in the door boot. remove the 10mm bolt holding the "massive harness" in the drivers kick (same place where you got park lights / brake).. and pull out the door harness going into the drivers door. Slice it open, and use red (arm), and blue for disarm

posted_image

Posted By: buddyle2002
Date Posted: March 07, 2020 at 5:24 PM

Just standard key, no system alarm.

Posted By: buddyle2002
Date Posted: March 07, 2020 at 5:32 PM

I can't seem to find the right wires, I see multiple red and blue as you can see the picture attached. Unsure which one are the right one to connect.

posted_image

Posted By: djdeito
Date Posted: March 07, 2020 at 7:14 PM

Have you checked in the location suggested by "silvercivicsir"?