Prostart CT-3371 Won¡¦t Crank Starter, 2009 Pontiac Vibe

I have gone over my wiring 5 times. when i try to remote start, the park lights flash once like they should, then it goes into start mode and a weird whining noise happens. The start failes and repeats three times, with the same hi-whine noise. I can crank it over with the key but not with the remote. Cant pinpoint where its comming from. First time I've ever run into this. I have installed this on a 2009 Pontiac Vibe automatic. Does anyone have any ideas on what i might have done wrong or what to look for. Any help on this puzzel whould be greatly appreciated. Tim B

I am using the TBXkey general transponder bypass with this R/S. This is the one Canadian Tire sold me with the R/S.

you hooked up both ignitions and both starters? you don't need accessory for this car. will it start with the key in the ignition?

Here is the wiring diagram for your vehicle, i hope this helps troubleshooting the issue:

Ignition switch White 8 Pin plug:
12V   (+) Blue or Red wire Pin# 7
12V 2 (+) Red wire        Pin# 2
Starter 1 (+) Black wire   Pin# 8
Starter 2 (+) White wire   Pin# 1 (needed only if your car is 2.4L)
Ignition 1 (+) Brown wire Pin# 6
Ignition 2 (+) Green wire Pin# 4
Accessory (+) Gray wire    Pin# 3

Ignition switch Black 7 Pin plug:
Code data Light Blue wire Pin# 4
Txct data Tan wire Pin# 5   

Obd2 connector:
Can High, Light Green wire Pin# 6
Can Low, White wire Pin# 14   

Parking light (-) Brown wire Pin# 18 @ parking light 20 Pin plug