Print Page | Close Window

2003 Chevrolet Silvarado SS, Viper 4806V

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=146034
Printed Date: May 01, 2024 at 6:02 PM


Topic: 2003 Chevrolet Silvarado SS, Viper 4806V

Posted By: flightrn
Subject: 2003 Chevrolet Silvarado SS, Viper 4806V
Date Posted: February 20, 2020 at 7:46 PM

recommendations for bypass module/ interface/combo for this install. It has been a few years since my last install and there is too much information out there now. I do not want to mess with flashing. GMDLBP vs PKALL vs DB3? or others. This vehicle has a hard tonneau cover with a Dakota Digital actuated lift. Need 3 (-) output aux channels to raise /lower. Liked the Viper the best.



Replies:

Posted By: kreg357
Date Posted: February 20, 2020 at 8:21 PM
While you would have to hardwire the interconnections between the bypass module and the Viper, my vote goes for the Fortin INT-SL+. The INT-SL+ comes pre-flashed and is a solid performer. Here is a link to the Install Guide :
https://cdn02.fortin.ca/download/46281/int-sl+_revj.pdf

-------------
Soldering is fun!




Posted By: flightrn
Date Posted: February 21, 2020 at 9:59 PM
thanks
will the int-sl+ trigger the heated seats and rear defrost?




Posted By: kreg357
Date Posted: February 22, 2020 at 5:06 AM
Yes it will if the truck is equipped with those features. There is one gothcha.
Here is the note from the install guide :
Note : Heated seats will turn ON (low power) ONLY if the engine temp is below 0°C (32°F) when remote started.

-------------
Soldering is fun!




Posted By: flightrn
Date Posted: February 26, 2020 at 5:39 PM
viper 4806v and int-sl+
int has a unlock driver 2 but viper does not.? will hitting unlock twice unlock both doors?

2003 ss has a 2nd accessory (brown) will this need to be energized by relay? (with the orange accessory +output)




Posted By: kreg357
Date Posted: February 26, 2020 at 8:57 PM
Unlock Driver 1 and Unlock Driver 2 has to do with the trucks personalization settings. See Page 2-66 in the Owners Manual.
Basically, you will see a Driver 1 or Driver 2 message appear on the instrument cluster depending on which Factory FOB/remote you use to unlock the truck with.
The INT-SL+ will allow similar functions depending on the connections between the R/S and the bypass.

I personally power the Brown ACC2 wire during a R/S. It might not always be required but I try to duplicate a standard key start up with my R/S wiring.
You would need a 30/40 Amp SPDT relay controlled by the Vipers thin Orange (-) 200 mA ACC wire.

-------------
Soldering is fun!




Posted By: flightrn
Date Posted: March 02, 2020 at 2:02 PM
awesome install thanks to your assistance. 3 Auxiliary functions run the tonneau cover amazingly well. Great range and everything works! saved $300 from what the local installer wanted.





Print Page | Close Window