door trigger/700IQ to new RS3
Printed From: the12volt.comForum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=14607
Printed Date: November 09, 2025 at 4:59 PM
Topic: door trigger/700IQ to new RS3
Posted By: antonio_resayo
Subject: door trigger/700IQ to new RS3
Date Posted: June 08, 2003 at 9:47 AM
Here is my question :
In the car now, there is a 700IQ(pic above, top diagram) the gray wire going to a negative door trigger/dome light.
Disarm and the dome light goes on for thirty seconds and then turns off-I can hear the relay. Armed-when you open the door of course, the door trigger/dome light turns on sending a signal/tripping a zone.
Now that I am installing the RS3, I know that I am going to be using the GREEN/ negative door trigger input. Am I going to need any extra relays, or diodes for the domelight supervision light wire on the RS3? Tie them all in one(door trigger and domelight supervision? :confused:
Please HELP. Thank you in advance for your time.
Replies:
Posted By: nighthawk2k
Date Posted: June 08, 2003 at 8:28 PM
Since it's a DEI product now. yes you have to use a relay set it up to throw ground.
Door side on 30 and ground on 87-or vise versa. On the RS3 use the BLACK/ white wire in the Primary harness on 86 and +12 volts fused on 85.
-------------
Tommy
-Clifford/Directed/Alpine-Audio & Security-
New York Installer
Door side on 30 and ground on 87-or vise versa. On the RS3 use the BLACK/ white wire in the Primary harness on 86 and +12 volts fused on 85.
-------------
Tommy
-Clifford/Directed/Alpine-Audio & Security-
New York Installer