2011 Toyota Sienna, Avital 4103 and FLCAN
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=146375
Printed Date: May 06, 2024 at 7:39 PM
Topic: 2011 Toyota Sienna, Avital 4103 and FLCAN
Posted By: redciv1
Subject: 2011 Toyota Sienna, Avital 4103 and FLCAN
Date Posted: August 04, 2020 at 8:51 PM
Our 2012 Sienna base was totalled in June. Found a 2011 LE to replace the totalled van. I installed the Avital 4103 remote start on the 2012 van with no problems 3 years ago. I pulled the remote start system from the old van. It was a base model with no G key.
I went to install the same remote starter on the new van and realized it has a G key with Immobilizer. So I purchased the FLCAN from Flash Logic and uploaded the correct program and the van is doing the same thing as before. It will attempt to start for 6 seconds and then shut down. If I put the key on the of ignition (not turned, just inserted into the slot, then the van starts. Seems like its just Key Sense. Anyone with information?
-------------
It's for me!!!
Replies:
Posted By: silvercivicsir
Date Posted: August 04, 2020 at 11:09 PM
did you program the FLCAN ? when the van attempts to remote start, does the led on the flcan come on? did you program it for DBI mode?
|