2009 Dodge Avenger, Door Locks
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=146484
Printed Date: May 14, 2025 at 11:25 PM
Topic: 2009 Dodge Avenger, Door Locks
Posted By: bofolton1
Subject: 2009 Dodge Avenger, Door Locks
Date Posted: October 08, 2020 at 1:59 PM
I bought a 2009 Dodge avenger without any entry remote and I want to install an aftermarket door lock kit to the existing lock system,how can I perform this..any wiring diagram? I noticed 4 wires running to the lock motor on drivers door two of them the colored ones reverse polarity when I lock or unlock on the door locks panel, but the signal is to fast to measure the voltage is a quick pulse.
Please any one help me to how install this aftermarket for entry kit...Thanks
Replies:
Posted By: wirewise
Date Posted: October 08, 2020 at 2:10 PM
This vehicle has a one wire system.
POWER LOCK LIGHT GREEN/PURPLE (-) thru a 330 Ohm Resistor, @ UNDER DRIVERS DASH, LIGHT GRAY 43-PIN PLUG, PIN 28
POWER UNLOCK USE POWER LOCK WIRE (-) thru a 100 Ohm Resistor
-------------
~wirewise~
Verify all wiring with your meter before making any connections!
Posted By: bofolton1
Date Posted: October 08, 2020 at 2:38 PM
Thanks.:D
Posted By: bofolton1
Date Posted: October 08, 2020 at 9:49 PM
Hello, does anyone know where I can find the gray 43 pin connector diagram layout, this plug is located under the steering column.
Thanks
Posted By: silvercivicsir
Date Posted: October 09, 2020 at 11:24 AM
Posted By: bofolton1
Date Posted: October 13, 2020 at 9:25 AM
Thank you very much, very helpful
|
