Scytek A15 Light Flash Output, 2009 Dodge Ram
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=146606
Printed Date: May 06, 2024 at 2:42 AM
Topic: Scytek A15 Light Flash Output, 2009 Dodge Ram
Posted By: aaron hernandez
Subject: Scytek A15 Light Flash Output, 2009 Dodge Ram
Date Posted: December 16, 2020 at 7:42 PM
Hi im new to the group and having problems with the scytek a15 powerlocks. I have everything connected and working except for the light flash output i have tried to connect to the parking lights but nothing flashes i know the wires are getting power. Its a 2009 dodge ram and i may be a little bit of a noob to this so anything helps. Im all out of ideas on where to try to connect it.
-------------
Aaronh.h
Replies:
Posted By: kreg357
Date Posted: December 16, 2020 at 8:53 PM
There are a couple of ways to achieve this. If you want to stay inside the cab, use the Light MUX wire. Set the A15 to (-) Parking Light output.
Place a 1.1 k ohm resistor in the A15 Parking Light output wire and connect to this wire listed below :
PARKING LIGHTS ( - ) WHITE (- THRU 1,000 OHM RESISTOR) @ HEADLIGHT SWITCH, PIN1, BLACK 10-PIN PLUG
Please note that some wire guides list the White/Green wire on this plug instead of the White wire. Additionally, DEI suggests use of TechTip 1082.
Bulldog Security lists a 1 k ohm resistor so be prepared to do some testing to determine the best resistor value.
-------------
Soldering is fun!
|