Compustar 7200, 2002 Toyota Sequoia Problem
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=146639
Printed Date: April 29, 2024 at 3:51 AM
Topic: Compustar 7200, 2002 Toyota Sequoia Problem
Posted By: furious440
Subject: Compustar 7200, 2002 Toyota Sequoia Problem
Date Posted: December 29, 2020 at 10:54 PM
Hello Ladies & Gents!
I am new to Compustar. Very experienced with DEI.
I have a problem with a 2002 Sequoia Limited with factory security. I am using the Ground When Armed, blue/white wire on CN5 to disarm the factory alarm at the 2 pin connector at the ignition switch. It is soldered to the yellow/green wire.
It will remote start. But will cause the factory alarm to honk the horn until the engine fires! What am I missing here? Any help is greatly appreciated!
Replies:
Posted By: MX6boii
Date Posted: December 29, 2020 at 11:07 PM
Hey Furious440,
I just checked the wiring diagram on this unit. Why not use Pin 9 Orange/Black on that harness which is for Factory Alarm Disarm? Will provide a negative pulse during unlock and ground when running during the remote start sequence also.
Posted By: furious440
Date Posted: December 29, 2020 at 11:36 PM
Thanks for the reply MX6boii
I was just looking at that too. You may just have the answer. Thank you.
|