2015 Landrover Evoque
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=146648
Printed Date: April 27, 2024 at 6:07 AM
Topic: 2015 Landrover Evoque
Posted By: bogucki
Subject: 2015 Landrover Evoque
Date Posted: January 03, 2021 at 2:14 AM
hey has anyone done a land rover evoque, i want to do one and have a few questions about it, i think i have it mostly figured out.
-------------
BOGUCKIALEX
Replies:
Posted By: wirewise
Date Posted: January 03, 2021 at 2:31 AM
What are you wanting to install and what questions do you have about it?
-------------
~wirewise~
Verify all wiring with your meter before making any connections!
Posted By: bogucki
Date Posted: January 03, 2021 at 10:49 AM
hey, i want to install a compustar cm7200 with drone, i know this car is not supported but i know a few people have done it. i know the install will take place behind the glove box at the bcm. i know i will need the dei 1101t smart key box for the immo bypass, i know its 15/16 connections i will need to make as follows
12 volts in to power the cm7200
ignition IN only for ign sense for cm7200
PTS 1 (-)
PTS 2 (-)
lock (-)
unlock (-)
start1 (+) (brake pedal activate)
start2 (+) (start request)
4 park light wires diode isolated
brake shut down wire to under dash light to shut down car when door open
then the wires for the dei 1101T
ok now for my 2 questions
for the pts wires i wanted just to use the poc outputs from the cm7200, but some say i will need a relay with a good ground and a 250 ohm resisters on the wires to activate the pts wires, wanted to confirm this
and 2nd i see on pro demand this car has some sort of brake diag wire at the brake switch that goes open when pressing the pedal down. will i need to do this with a relay as well for the remote start to to work?
-------------
BOGUCKIALEX
|