Blade AL Doesn’t Seem To Work At All, CM900-AS, 2007 Toyota Camry
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=146823
Printed Date: April 19, 2024 at 12:00 PM
Topic: Blade AL Doesn’t Seem To Work At All, CM900-AS, 2007 Toyota Camry
Posted By: prezdead
Subject: Blade AL Doesn’t Seem To Work At All, CM900-AS, 2007 Toyota Camry
Date Posted: April 24, 2021 at 3:09 PM
So Ive installed a CS7900 (CM900AS) Have all wires connected the way idata shows and the high power ignition harness connected to. lock/unlock isnt doing anything with the locks,(from my understanding its suppose to control locks and trunk) just sets the alarm. Ive gone through the tach learn process, but it will not start. Ever thing comes on live the key is in the ignition and the chime for the ignition chimes, but it will not turn over. It trys 3 times and then give me error 8 which is Tach or tachless sensing failure.
Vehicle is an 2007 Toyota Camry with Standard key
Replies:
Posted By: chev104275
Date Posted: April 27, 2021 at 6:34 AM
Was the blade flashed with the correct firmware ? Did you go through the programming process ?
-------------
If i Can't Install it I Don't need it Joe
Posted By: mgoetz74
Date Posted: April 28, 2021 at 3:06 PM
did you hook up a second starter wire? Should be 2 starter wires blue is the main one and grey would be second which you'd need a relay to energize. You also have 2 ignition wires yellow and pink. usually use the poc #2 blue/green pin 2 on the cn3 as 2nd starter wire. Can change it easier with a op500
https://images.idatalink.com/corporate/Content/Manuals/DL-TL1/BLADE-AL(DL)-TL1-EN_20140604.pdf
-------------
33 years as a installer now just a retired old guy. Favorite thing to install/topic are remote starts/car alarms. Stop using test lights!!!
Posted By: prezdead
Date Posted: April 29, 2021 at 11:06 PM
Sorry its taken so long for me to respond. I did flash it on idata and this is the wiring i followed. As My starter was sold as a 7900AS, I assumed this wiring was correct as everything matched up on every wiring diagram I had.
Wiring
the blue/green wire i used to be able to lock the door as the blade wasnt even doing that. I guess I completely misunderstood what the blade al was saying it did because even with following the wiring guide from idata, it wouldnt even control the door locks. So as for now Im just giving up on the remote start. I got the security system to work on it and thats the main reason i got it. Just had hoped the remote start would be an added bonus. Thank you for your replies.
Posted By: chev104275
Date Posted: April 30, 2021 at 8:09 AM
I assume you flashed it with BLADE-AL(DL)-TL1 ? you said it was flashed but did you go through programming when you were finished the install ?
-------------
If i Can't Install it I Don't need it Joe
|