2009 Dodge Challenger SRT8 6 Speed Manual, CM7200S
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=147263
Printed Date: April 29, 2024 at 12:17 PM
Topic: 2009 Dodge Challenger SRT8 6 Speed Manual, CM7200S
Posted By: devon1320
Subject: 2009 Dodge Challenger SRT8 6 Speed Manual, CM7200S
Date Posted: February 16, 2022 at 8:28 PM
Ok so I severely need help figuring this out. I have checked all my wiring and made sure everything was programmed and I’m at the end of my rope short of throwing away the whole car. I installed a Compustar cm7200s with a blade bypass module and everything is all correct and works as it should except I’m having one issue. I put it into reservation mode and get out and shut the door and the system locks the car and shuts down. When I try to remote start it, it starts up runs for 3-5 seconds then shuts off and shows a door triggered code on my 2w901-ss LCD remote. PLEASE HELP ME
***Ok after some rechecking and checking all my connections again I unplugged the door ajar wire and the car will remote start and run fine as long as it's disconnected. It appears to be an issue with the "rearm out" signal wire that shuts everything down. Every time I remote start the car or lock or unlock my system, it causes the car and light to all pulse off and on like 2 or 3 sets and it's doing it long enough for the remote start to see that it is tripping the door ajar warning. Is there a way to decrease the amount of pulses related to the rearm out wire?
-------------
2009 Dodge Challenger SRT8 6 Speed manual
|