2014 Ram, Prostart TW3400, ADS ALCA Programming Issue
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=147290
Printed Date: May 04, 2024 at 12:58 PM
Topic: 2014 Ram, Prostart TW3400, ADS ALCA Programming Issue
Posted By: bruc007
Subject: 2014 Ram, Prostart TW3400, ADS ALCA Programming Issue
Date Posted: March 14, 2022 at 6:36 PM
Hey . I am installing an older prosart tw3400 in a 2014 Ram Base Model. It is hardwired as well and no options to choose which bypass . I am using an ADS ALCA bypass with CH8 ver 2.3 software.
All seems good, clone fine but upon activation the truck does everything but crank. The module when activated goes from green to solid red quickly. Any thoughts?
Replies:
Posted By: silvercivicsir
Date Posted: March 15, 2022 at 9:40 AM
did you put the bypass in hardwire mode? two flash vs one flash, when programing? .. does the Tw3400 have a data port? it should from what i remember, and you can use dbi mode.
Posted By: bruc007
Date Posted: March 15, 2022 at 1:48 PM
It is in hardwired mode. And it doesnt have a data port for the module. Also there is no settings to change protocols.
Posted By: silvercivicsir
Date Posted: March 15, 2022 at 9:27 PM
Do the door locks work? From the aftermarket fob?
Posted By: hav007-roco
Date Posted: April 13, 2022 at 1:27 AM
That unit requires tach to be hardwired directly. Also double check ground out when running. The units gwr may be burnt, ground directly for test. If u are getting red flashes on alca during start, chart says something to do with bypass incorrectly hooked up or programming.
-------------
Rocky Verma
|