Print Page | Close Window

How To Wire Directed 415M To InstallGear Actuators?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=147396
Printed Date: December 04, 2022 at 5:40 AM


Topic: How To Wire Directed 415M To InstallGear Actuators?

Posted By: evetts
Subject: How To Wire Directed 415M To InstallGear Actuators?
Date Posted: June 25, 2022 at 11:01 AM

Greetings all. Having some trouble trying to figure out how to wire this relay to the actuators. This is on an older ford truck without factory power locks. I installed an Avital 3100LX, and now I want to use the power lock feature in the alarm to add power locks to my truck. So I plugged the 3 wire connector from the relay into the alarm, and when I arm and disarm the alarm, the 451M clicks, so I think we’re good there. My question is, how do I wire this relay to the actuators? The actuators only have two wires each- a blue wire and a green wire. The relay has 5 wires coming out of it- the violet one obviously goes to constant 12v, but I can’t figure out the other wires- white, green, blue, brown (all with black stripe). I want to assume blue to blue and green to green and the others are unused? I would assume one would go to ground?

Yes the relay came with instructions but they suck, so any advice is greatly appreciate!



Replies:

Posted By: mgoetz74
Date Posted: June 25, 2022 at 1:58 PM
white and brown to ground, blue and green to the blue and green of the actuator. purples to 12+

-------------
31 years as a installer. Favorite thing to install/topic are remote starts/car alarms. Stop using test lights!!!




Posted By: evetts
Date Posted: June 25, 2022 at 6:45 PM
Awesome, thank you so much!





Print Page | Close Window