Print Page | Close Window

5 Wire Central Locking Issue

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=147650
Printed Date: March 29, 2024 at 12:44 AM


Topic: 5 Wire Central Locking Issue

Posted By: itskv
Subject: 5 Wire Central Locking Issue
Date Posted: April 26, 2023 at 1:33 PM

I have a 5-wire door actuator and a central locking box. I do have a Viper 5706v - blue/green to spare white/brown on the control box harness.
I have my actuators set up for reverse push/pull, Blue/Green & White/Brown are swapped at the actuator.

The system has been working for a few years and recently stopped responding (clicking is still heard from the box). Found out that some of the wiring on the harness at the actuator door was an issue and made new terminal connections there.

With the new terminals, now the actuator only responds to lock, but not unlock - vice versa if I flip the blue/green & white/brown. I put a voltmeter on the box harness side and can see ~6v to 7v when I unlock/lock at the blue/green pin on the harness connector. Could this be an issue? (the actuators do respond to lock or unlock depending on the wiring)


I've tried:
new 5-wire actuator - same issue, no change
new control box, same issue, no change






Print Page | Close Window