Micro Keyless Entry Switch Configuration
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=147676
Printed Date: April 25, 2024 at 12:31 AM
Topic: Micro Keyless Entry Switch Configuration
Posted By: vicfreg
Subject: Micro Keyless Entry Switch Configuration
Date Posted: May 20, 2023 at 7:30 AM
I have a Micro keyless entry system (DLR4V) I am going to install in my car. I have 2 wire actuators on each door. I have the system on my bench, wired up, and it works properly with the remote controls. I also want to wire in 2 momentary push buttons that are on my console, one for the lock, and one for the unlock. The switches are SPDT. The keyless entry system is designed to be used with a 6 pin momentary rocker switch. I want to use the 2 pushbuttons instead of the 6 pin switch. I can't figure out how to wire the 2 switches to the keyless entry to make it work with these switches.
Here is the link to the wiring diagram.
https://manualzz.com/doc/6413966/keyless-entry-dlr4v
The White/Black and the Brown/Black are the wires I need to interface with my 2 SPDT momentary pushbuttons.
Any help would be appreciated!
Vic
-------------
Mustang Vic
Replies:
Posted By: cpalmer
Date Posted: May 21, 2023 at 11:41 AM
Doesn't look like it would work that way. The relays that you would need to trigger with your console switches are built on to the board of the Micro keyless. I think it would be better to get a dedicated Lock/Unlock switch and wire it in properly.
Posted By: vicfreg
Date Posted: May 23, 2023 at 6:17 AM
Yes, you are right. I need a reversing polarity set up, which I cannot do with the existing switches I have. Thanks for the help!
-------------
Mustang Vic
|