Carlink ASCL6 Install On Prestige APS997Z
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=147683
Printed Date: April 27, 2024 at 7:47 PM
Topic: Carlink ASCL6 Install On Prestige APS997Z
Posted By: tenchu
Subject: Carlink ASCL6 Install On Prestige APS997Z
Date Posted: May 26, 2023 at 9:21 PM
Im getting my rear end kicked here. I cannot manage to figure out how to enable telematics on weblink with this setup. I looked at the documentation with the carlink and it says I need to change the protocol, but weblink is only showing idata protocol, and when I get to the flash page where I can modify the telematics setting, it just brings me back to the firmware selection page. Anyone have any suggestions? I would greatly appreciate any assistance.
For reference this is going into a 2019 Subaru WRX STi with manual key.
The alarm/remote start has been in and working for a few months, just trying to add carlink.
Replies:
Posted By: audiokid1
Date Posted: May 27, 2023 at 6:22 PM
Possible cause....?
Posted By: tenchu
Date Posted: May 27, 2023 at 7:09 PM
I actually figured it out literally minutes ago. The protocol setting it was taking about was actually within the CL6 app itself. Unfortunately I couldn’t manage to change it on Android, but on iOS I had to press and hold the protocol setting for 10 seconds to be able to change it to ADS and then it worked.
Thank you for your reply!
|