2016 Toyota Camry, Starter Kill Relay, Compustar CMX
Printed From: the12volt.comForum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=147938
Printed Date: May 10, 2025 at 5:20 PM
Topic: 2016 Toyota Camry, Starter Kill Relay, Compustar CMX
Posted By: baby007
Subject: 2016 Toyota Camry, Starter Kill Relay, Compustar CMX
Date Posted: February 23, 2024 at 7:12 PM
Replies:
Posted By: kreg357
Date Posted: February 24, 2024 at 8:39 AM
Posted By: baby007
Date Posted: February 24, 2024 at 11:50 AM
Posted By: kreg357
Date Posted: February 24, 2024 at 12:14 PM
By "Data" I'm guessing that you are using a Blade AL cartridge flashed with the TL-9 firmware and following the Type 1 install wiring as shown in the Doc #82279 Install Guide.
First you will need the High Power 8 Pin CM-X harness. Your Camry has high current IGN1 and Starter1 wires at the ignition switch.
The Starter Kill / Anti-Grind feature is an option. If added during the install, the Anti-Grind would prevent starter grind during R/S key takeover if you rotated the key too far - into the START area. The Starter Kill function would prevent the vehicle from cranking the starter if the CM-X system was Locked and Armed. As mentioned, this is an optional feature. You would use a relay that interrupted the Starter1 wire. The relay would be controlled by the CX-X's GWA output. There are some programming options for the GWA output. See Menu 3-4 for more info.
-------------
Soldering is fun!
First you will need the High Power 8 Pin CM-X harness. Your Camry has high current IGN1 and Starter1 wires at the ignition switch.
The Starter Kill / Anti-Grind feature is an option. If added during the install, the Anti-Grind would prevent starter grind during R/S key takeover if you rotated the key too far - into the START area. The Starter Kill function would prevent the vehicle from cranking the starter if the CM-X system was Locked and Armed. As mentioned, this is an optional feature. You would use a relay that interrupted the Starter1 wire. The relay would be controlled by the CX-X's GWA output. There are some programming options for the GWA output. See Menu 3-4 for more info.
-------------
Soldering is fun!