03 Altima SE
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=15071
Printed Date: September 16, 2025 at 7:38 AM
Topic: 03 Altima SE
Posted By: raydawg357
Subject: 03 Altima SE
Date Posted: June 17, 2003 at 10:01 AM
Just installed an alarm in this vehicle and the unlock pulse causes the front windows to roll down about 2 inches. Can this be avoided. I've tried programing the alarm to single pulse.
-------------
Do it right the first time
Replies:
Posted By: patmar
Date Posted: June 17, 2003 at 8:41 PM
i, i'm installing a remote start in a 2003 2.5 altima. use double pulse for unlock in this car
Posted By: djfearny2
Date Posted: June 17, 2003 at 8:46 PM
how long is the lock pulses cause as you know the lock wires also control the windows up and down built in the doors try changing the lock pulses to shorter times. the way the windows work are as follows when you put the key in the door and turn it one way and hold it the window will either go up or down and so on for the other direction change the pulse times to lower times. with dei products you can if that does not work try resistors. or something what alarm are you using email me.
-------------
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.
Posted By: raydawg357
Date Posted: June 18, 2003 at 7:23 AM
Thanks for the replies, but as I initially stated, I have switched to shorter pulses. Should I try a resistor?
-------------
Do it right the first time
|