APS-995C, APS996 installer Programming

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=15124
Printed Date: September 16, 2025 at 9:25 AM

Topic: APS-995C, APS996 installer Programming

Posted By: cherring69
Subject: APS-995C, APS996 installer Programming
Date Posted: June 18, 2003 at 4:31 PM

Anyone know the trick to get into installer programming on these systems? I've tried the ignition on, valet 3 times, ignition off, then ignition on again, but I'm not getting (or don't appear to be) into installer programming, only the channel programming (for the buttons on the remote).

I fixed the earlier problem I was having by relocating the antenna- but still can't get in to change the programming options. HELP!

TIA

QnD

Replies:

Posted By: Chris Luongo
Date Posted: June 19, 2003 at 5:45 PM

You could always double check that your thick blue wire is connected to true ignition; that could never hurt.

Not sure if you noticed this, but the procedure to program and alarm features is different from the remote start ones.......and the remote start ones are much easier to set, so try doing them first.

Print Page | Close Window