Remote Start Problems
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=15205
Printed Date: July 21, 2025 at 4:47 AM
Topic: Remote Start Problems
Posted By: blkjava
Subject: Remote Start Problems
Date Posted: June 20, 2003 at 9:47 AM
I have a 1999 Lincoln Navigator I just completed an installation of a CrimeStopper CS-2011RS Series 111 with remote start. The problem is the remote start will turn-over the engine but will not start and run I went to a dealer they told me I have to buy a new for $400.00 to be placed in the brain of the alarm for it to work because my keys have a security chip that the computer have to read before my truck can starts....Any advise?
-------------
A sabato
Replies:
Posted By: Velocity Motors
Date Posted: June 20, 2003 at 9:52 AM
They are full of it !! You can purchase a byapss module that will take care of the problem for about $ 40.00 and you do not loose a key out of the deal either. You do need two active keys to program the module though. ------------- Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: blkjava
Date Posted: June 21, 2003 at 12:25 PM
Velocity Motors wrote:
They are full of it !! You can purchase a byapss module that will take care of the problem for about $ 40.00 and you do not loose a key out of the deal either. You do need two active keys to program the module though.
I found under my dash a universal bypass module DEI 555U with a key inside the problem is the wires are all disconnected how do i reinstall this unite......Wire colors. 2 pin socket (1black 1blk-white) next a 3 pin socket (wire color......Red,Blue, and White ------------- A sabato
Posted By: Velocity Motors
Date Posted: June 21, 2003 at 3:53 PM
RED wire goes to constant. BLUE wire is your negative out from alarm . WHITE wire is not needed & the plug for the ring that goes around the steering column plugs into the 2 pin socket.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: blkjava
Date Posted: June 21, 2003 at 6:04 PM
Velocity Motors wrote:
RED wire goes to constant. BLUE wire is your negative out from alarm . WHITE wire is not needed & the plug for the ring that goes around the steering column plugs into the 2 pin socket.
Thanks Jeff .... Your help is well acknowledge ------------- A sabato
Posted By: Velocity Motors
Date Posted: June 22, 2003 at 8:45 AM
No problemo.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: blkjava
Date Posted: June 22, 2003 at 10:03 AM
Velocity Motors wrote:
No problemo.
Hey Jeff I made the connections as you stated.... The truck starts up and idle but i can still hear the starter running and the security light comes on and then it shuts off....Problem #2 the remote no longer open-n-closed the doors....the park lights stop flashing.... ------------- A sabato
Posted By: Velocity Motors
Date Posted: June 22, 2003 at 11:00 AM
Did you connect up all the necessary ignition iwres ? IGNITION|blue/lt. green |+ |ignition harness |
| SECOND IGNITION|gray / YELLOW(2nd acc)|+ |ignition harness |
| ACCESSORY|RED / black |+ |ignition harness |
| SECOND ACCESSORY|BLACK/ green |+ |ignition harness | Also, make sure that the tach wire is programmed to the vehicle. If the starter is dragging, chances are the installer's never programmed the tach wire to the Lincoln. ------------- Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: blkjava
Date Posted: June 22, 2003 at 4:08 PM
Ok.... ?do I have to connect a relay to each Ignition .....because i connect a relay and now the security light is off...the sound like when you have a weak battery and just will not turn-over.... Relay Connections i did its was pre-wired... yellow connect to orange wire from alarm........Blue wire connect to IGN #1.....then i cut the starter wire connect one end.... Orange to starter wire from IGN ......other Orange to Starter Wire... ------------- A sabato
Posted By: Velocity Motors
Date Posted: June 22, 2003 at 5:35 PM
Both IGN wires have to be connected in order for the RS to work properly. If the RS has a (+) output second IGN wire then all you need to do is hook it straight up to the 2nd igntion wire. If it's a (-) for a relay then you need to use the relay diagram above, but only for the second ignition wire. The primary ignition wire is already a (+) output.. Also, make sure that you learn the tach.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: blkjava
Date Posted: June 22, 2003 at 9:03 PM
? Do i need to used 2 relays.....one for IGN#1 and one for IGN#2 Here is the RS connector : IGN #1 pink wire.....IGN#2 pink/white.....ACC gray wire.....Start brown wire..... Red +12v......Red +12v ------------- A sabato
Posted By: Velocity Motors
Date Posted: June 22, 2003 at 10:20 PM
No just one for IGN # 2. IGN # 1 is already a 12 volt + .......unless of course your unit has a 12 volt + 2 IGN output, then you do not need a relay for 2 nd IGN.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: IllusiveG20S
Date Posted: June 25, 2003 at 6:23 AM
Velocity Motors wrote:
They are full of it !! You can purchase a byapss module that will take care of the problem for about $ 40.00 and you do not loose a key out of the deal either. You do need two active keys to program the module though.
Do they make one for an Infiniti? I am trying to do remote start with my car and they are charging me 200 bucks to do it, seems a lil expensive.
Posted By: IllusiveG20S
Date Posted: June 25, 2003 at 6:50 AM
Thats with the Clifford 7000
Posted By: blkjava
Date Posted: June 25, 2003 at 8:38 AM
Thanks Jeff.....the remote starter is working now
-------------
A sabato
Posted By: Velocity Motors
Date Posted: June 25, 2003 at 9:05 AM
IllusiveG20S, what year G20 do you have ?? It's probably a 2000-2002 ? You will need a universal bypass kit where you have to loose a key in order for the remote start to work. It costs about $ 20.00 for one of these, not $ 200 like the dealer says  If the G20 is older than 2000, then you do not need one at all. ------------- Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: Velocity Motors
Date Posted: June 25, 2003 at 9:17 AM
blkjava..... No problemo
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
|