Viper C30

The line of Viper products have not changed color code for years and years

red=12v--yellow=ign--brown=neg siren--black=ground--green=neg door trigger

purple=pos door trigger--white= light flash--red w/white stripe=ch1 neg output

let me know if you need more , this should get it working for you

i dont recall if the led and the disarm switch are wire in or plug on that 1 so

grey=disarm------blue w/white = led neg          if it is wire in

Any fused 12v source is ok for the led , it is only a 2.2 v led however it is the blue white that regulates the voltage to the led. and yes the disarm and valet are one in the same.

If you are going to put in a shock sensor you would use the blue wire as the neg trigger ( it is also the hood and trunk) and if you use it for more that 1 thing make sure you diode isolate it.

As far as the rest of the shock sensor wires they should be self explanitory, red=12v---black=ground----blue = neg trigger----and if it has an orange instead of a black connect it to the orange on the alarm( witch can also be used for starter disable) the one off the alarm that is

the diagrams for the starter disable and how to diode isolate are in this site .and how to relay the channel 1 wire for your trunk release. as far as the other valet switch wire ground it!!!!!!!!! I wish you the best..