Print Page | Close Window

Hood pin switch not setting off alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=15630
Printed Date: March 22, 2026 at 11:17 AM


Topic: Hood pin switch not setting off alarm

Posted By: phamine
Subject: Hood pin switch not setting off alarm
Date Posted: June 29, 2003 at 7:39 PM

My doors and trunk are setting off the alarm. The pin switch for the hood is not setting the alarm off though. I did replace the pin switch and remounted it in the middle of the hood near the firewall.

My original pin switch was held on by a metal plate and then attached to the car. Right now the switch is mounted on plastic. Should I use a metal plate to mount the switch?




Replies:

Posted By: Velocity Motors
Date Posted: June 29, 2003 at 7:45 PM
Yes, the hood pin switch has to see ground ( metal ) when it is in the up position.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA




Posted By: phamine
Date Posted: June 29, 2003 at 8:25 PM

Thanks for the tip. I'll try to ground it tommorrow and take some pics of the location where I have it mounted. Would you be able to help me with this question?

https://www.the12volt.com/installbay/forum_posts.asp?tid=13587&KW=antenna 

I'm trying to install a DEI range antenna onto a viper 300+ alarm module. Where am I supposed to hook up the 2 wire connector?






Print Page | Close Window